Black and Decker WM125 Workmate 125 350 Pound Capacity Portable Work Bench

Black and Decker WM125 Workmate 125 350 Pound Capacity Portable Work Bench | Good product depending on your needs

tools & hardware:

Black and Decker W...

	Black and Decker WM125 Workmate 125 350 Pound Capacity Portable Work Bench Black & Decker Black & Decker average customer review:based on 21 reviews view larger image
	for more information click here

"WORKMATE" X-FRAME LIGHT DUTY WORKBENCH 350 lb. weight capacity provides sturdy work surface Jaws resist warping & swelling Includes swivel pegs and integral retention grooves in jaws for versatility and holding reliability in clamping difficult materials Folds flat for easy storage and portability Rubber feet prevent unit from slipping Dual clamp cranks Boxed

Nice little workmate for the money

Very confusing instructions but I got the tables (bought two) put together just fine. The parts fit perfectly but you must put it together correctly (hard to do from the instructions). The leg braces are of different widths so they must go on the correct legs (the widest brace - the one with the B&D label - goes on the widest set of legs). The roll pins to secure the handles to the screw shafts are too big. So, either compress them to a smaller size or better yet, replace them with 8-32 x 1-1/4 inch machine screws with nylon insert lock nuts. The machine screw route is a perfect fit and leaves no slack (play) so the handles will last longer. It took a while to get the tables together due to the confusing instructions but in the end it was well worth it. They are very nice tables for the price.

for more information click here

Good product depending on your needs

This may not be the best, most equipped or heaviest workmate on the market, but depending on your actual needs, this could be the best one for you. I looked at all the workmate benches, but figured for my basic needs, this one would do. After using it quite a lot, for about $20, I am going to buy another one to use them as saw horses or for working with long product. This is a solid bench that folds very flat, taking up very little space. It comes with four of the orange pegs and the vise is grooved for holding pipe under 2". For an active DIY guy, this one does the job for me, and when I am done, I will be able to hang both on the same set of wall pegs. The only con for me, is that you have to watch your fingers carefully when folding this unit flat.

for more information click here

Works well, but is difficult to assemble.

The WM125 works well. It's most important feature for me is that it really does fold up small. (I live in an apartment.)
It's strong and stable enough to support a Dremel 220-01 Rotary Tool Work Station without shaking.
The only completely negative thing I have to say is that the assembly directions were terrible. I'm an engineer, and I had to completely start over three times before I got it right. The directions are so bad that at one point, I thought one of the clamping jaws (wood panels) was drilled wrong at the factory and was preparing to redrill it myself. Fortunately, I realized that I just had the other one backwords, because the directions showed it that way.
I also have one concern that isn't certain yet, but I expect to become a problem: The locking nuts are slowly collapsing the steel square tube legs. Basically, the locking screws and nuts, which prevent the work station from collapsing while you use it, are much tougher than the tubing in the legs. (This is good from a safety point of view: Better that the leg gets squashed over time than that the work station collapses while you are working with a power tool.)
Both of those issues to the side, I still consider it an excellent buy. If it does fail on me, I'll probably just buy the next better version. The basic design is excellent.

for more information click here

reviews: page 1, 2, 3, 4, 5

products you might be interested in